IMPORTANCE OF BATTERY MAINTENANCE
Electronic motorcycle accessories, even the most basic ones (ECUs, clocks, key sensors) all draw a small current even when the ignition switched off. Often referred to as Parasitic draw. This can and will drain your battery voltage in as quickly as a few days. Prevent these draws from killing your battery, disconnect the battery. Even if there is no load on, batteries self-discharge. When batteries are left discharged, they quickly become sulfated and may permanently lose the ability to be charged. The best practice is to keep your battery on a maintainer at all times.
Storage and Charging
If a motorcycle is stored for several weeks or longer, keep it on a “smart” multi-stage maintenance charger. During extended storage, remove the battery and place it indoors, where it can be connected to a maintenance charger and the electrolyte level monitored. If that’s not possible, or if it’s maintenance-free, the battery can be left in the bike and on a battery maintenance charger. (A fully charged battery will not freeze until the temperature dips to -68 degrees Celsius, but when discharged, they can freeze at just a few degrees below the freezing point of water.) Often, we don’t expect to leave the bike as long as we do, so make it a habit to connect it when parking at home. Many chargers come with external quick-connect plugs that only take seconds to use.
Regular and trickle chargers are OK for recharging discharged batteries to put them back in service, but they don’t have the circuitry needed to maintain a battery’s charge properly during storage. When trickle chargers are left on for long periods they overcharge and damage batteries.
NOTE** Batteries should be recharged at a rate not exceeding 20% of their ampere-hour (A-H) rating
Conventional Lead Acid Vs. Lithium Technology
In most cases where you are still running the same OEM battery from when you bought the bike, it’s a lead acid. Although slightly dated technology, many benefits still exist for the conventional wet cell:
- Cheap to replace
- Robust can be brought back to life from nearly zero voltage
- Doesn’t require any special charging units
- Bulky, not much room to alter dimensions for custom projects due to wet cells
- Heavy, depending on where your battery tray is located, it can be a lot of weight up high on the motorcycle’s chassis
Lithium might be an upgrade worth considering if your looking for a replacement battery or simply looking to shed some weight.
- Lightweight, for the cost no other method is as cost-effective as shedding up to 40-65% static weight from the original battery
- Holds its charge, compared to other batteries Lithium alternatives lose only about 1% of it’s total Voltage over the course of a year.
- Doesn’t require to be on a charger if disconnected from bike, just store in a dry location
- No liquid, preventing any spillage
- Requires a specific LiFePo4 charger, conventional battery chargers can over charge and permanently damage your lithium battery
- High cost
- Can be temperamental in extreme climates, may require multiple cranks from starter to “wake up” the battery
Maintenance and Safety
Batteries contain sulfuric acid so always follow the safety warnings. Always wear eye protection, rubber gloves, and old clothing when working near them, and keep baking soda and water handy to neutralize any spilled acid. Batteries vent hydrogen and oxygen that can explode if sparks or smoking occur nearby. Shut the ignition switch off before disconnecting battery terminals, and detach the ground side first so tools can’t spark if they touch metal. Always connect the negative jumper cable for the dead battery last, attaching it to a clean metal portion of the frame, rather than to the negative battery terminal, so no sparks occur near the battery. Only plug in a battery charger after it’s connected.
Be sure to clean and inspect terminals regularly. Electrolyte levels of non-maintenance-free batteries need to be checked monthly, especially in hot weather or when frequently used. If electrolyte levels drop below the top of the internal plates, the battery may be damaged. Use only distilled water to refill, which prevents mineral buildup for proper battery maintenance.